The project measures RAS/SAS (raw activated sludge/surplus activated sludge) flow through sixteen lines of grey cast-iron pipes and features Profibus PA, the first clamp-on flowmeters to do so in the UK. Needless to say, all distancing and safe working practice protocols were followed on-site and Matt visited the site as an approved ‘critical supplier’ for the project.
Monitoring RAS and SAS is important in properly balancing sludge processes, so an accurate, repeatable measurement of flow is key. The sixteen lines being measured are grey cast iron, installed between the 1930s and 1950s, with diameters from 80 to 440 mm. The measurement was made more difficult by the presence of a build-up of sludge on the inside of the pipes, so KATflow 210 and 230 had previously been installed on a 24-hour process logging trial to prove the reliability of the measurement, leading to the order for permanently installed KATflow 150 units.
For the main installation, the sensors are positioned approximately 50 m from the control units. Katronic’s Audible Sensor Positioning Assistant helps when it isn’t possible to see the controller but, obviously, it has to be within earshot, so Matt Bird made use of Katronic’s small Remote Positioning Assistant, which allows a hand-held KATflow 200 to be used to set the sensors up before connecting them to the main controller.
Matt also installed Profibus PA interface boards into each of the KATflow 150s, allowing them to connect to the site supervisory control system. We believe that this is the first Profibus PA installation in the UK for non-invasive, clamp-on flowmeters.
